
Following are some corrections and additions to the 
Studio 64 XTC Manual:


----------------------------------------
Syncing to 29.97 Non-drop
----------------------------------------

The Studio 64 XTC automatically switches its SMPTE frame 
rate setting based  on received time code. For instance, if 
the interface is set to 24 fps and 25 fps is  received via 
the SMPTE IN jack, the interface automatically switches its 
framerate setting to 25.

One exception is when receiving 29.97 Non-drop. If the 
Studio 64 XTC is not set to 29.97 ND, receiving this format 
will cause the unit to switch to 30 ND. This has to do with 
the Studio 64 XTC (and all interfaces, for that matter) not 
being able to distinguish between 29.97 ND and 30 ND.

When receiving 29.97 ND, its very important that the Studio 
64 XTCs frame rate setting matches. If it doesnt, sync 
problems will occur when using Word Clock, Super Clock, or 
ADAT sync.

The frame rate for the Studio 64 XTC can be set from the 
front panel or from the SMPTE Window on your Mac or PC. If 
you intend to frequently use 29.97 ND, you can configure 
(and save) one of the Studio 64 XTC user programs to use 
that frame rate.


--------------------------------------------------------
Monitoring Blackburst and Video Signals
--------------------------------------------------------

If the Sync Reference mode is set to receive Video, the 
Video LED is lit  constantly when receiving the composite or 
Blackburst signal. When these  signals are not present, the 
Video LED blinks slowly.


-------------------------------------------
Default Sync Reference Setting
-------------------------------------------

The default Sync Reference mode setting is now Internal. 
Following is a  complete list of the default sync settings 
for the factory user programs:

-- Sync Reference Mode: Internal
-- SMPTE Frame Rate: 30 Non-Drop
-- SMPTE Start Time: 00:00:00:00
-- Freewheel: 10 frames
-- MTC Source: Computer
-- Digital Phase Lock: On
-- Sample Rate: 48 kHz
-- ADAT Online: On
-- ADAT ID: 0
-- ADAT Offset: 00:00:00:00


-----------------------------
Digital Phase Lock
-----------------------------

If you are not using digital audio hardware or an ADAT, you 
can disable Digital Phase Lock for faster lock-up when 
syncing to SMPTE or MTC. This sync option is stored in each 
user program and can be disabled/enabled from the Program 
Edit Window of your Mac or PC software. 

When enabled, the Digital Phase Lock option provides the 
most accurate sync  when using Word Clock and Super Clock 
with digital audio hardware.

NOTE: The Studio 64 XTC still generates Word/Super Clock 
when Digital Phase Lock is disabled. In this mode, audio 
sync is not as accurate though.

IMPORTANT: Digital Phase Lock must be checked if you are 
controlling an  Alesis ADAT from the Studio 64 XTCs ADAT 
Sync port.

There are, however, a few differences in the way the Studio 
64 XTC behaves  when Digital Phase Lock is disabled. 
Specifically, if Digital Phase Lock is off and the Sync 
Reference mode is set to MTC or MTC/Video...

-- SMPTE is not sent to the SMPTE OUT jack.
-- For Mac users, MTC is automatically sent to all MIDI OUT 
ports, and to  networked interfaces, when the MTC Source is 
the Computer.
